3.8.22.2 Using QuickSteer
1
2
GUID-514F77A0-D0A8-451B-94CD-21734C973825
1. QuickSteer control knob
2. QuickSteer activation button
1. To turn the steering valve on, press the QuickSteer activation button.
The QuickSteer activation button light is lit green, and the QuickSteer symbol
is displayed on the Proline instrument panel.
2. Turn the QuickSteer control knob to set the steering speed.
3. To turn the steering valve off, press the QuickSteer activation button.
The steering valve can be turned off only with the forward drive system.
When the driver's seat is turned to the TwinTrac reverse drive system
(optional equipment) the valve is always on, even if QuickSteer is not active.
Pressing the Auto-Guide steering valve ON/OFF button also deactivates
QuickSteer and activates the steering of Auto-Guide.
NOTE: If the light on the QuickSteer activation button or the Auto-Guide
steering valve ON/OFF button (optional equipment) is flashing, there is a fault
in the steering valve. A fault code is shown on the armrest display. Reset the
steering valve to recover from the fault.
When QuickSteer is activated, driving speed is limited to 25 km/h. You have
to deactivate QuickSteer in order to drive at a speed higher than the limit. If
you want to activate QuickSteer again, the driving speed has to be below 25
km/h.
NOTE: In case of a fault in the steering valve, the vehicle speed is forced to
ramp down and only slow speed driving (2 km/h) is allowed with the drive
pedal. Turning the steering valve off eliminates the driving speed restriction.
3.8.22.3 Resetting QuickSteer
3. Operation
- 154 -
Summary of Contents for Versu N Series
Page 1: ...OPERATOR SMANUAL NSERIES Versu Ref no 39 893 21 3 08 2015 YOUR WORKING MACHINE...
Page 2: ......
Page 517: ......
