13
NOTE
:
1. Do not use the system in the vicinity of strong electromagnetic field (for example a
transformer), which may affect the performance of the monitor.
2. Using devices transmitting RF signals in the vicinity of the system may affect the
system’s performance. Do not use or take any devices intentionally transmitting RF
signals such as cellular phones, transceivers and radio-controlled products in the room
placing the system.
3. Transport, store and use the system under the circumstance specified in this manual.
Additionally, store and use the system in a clean location where there is no direct
sunlight, no sudden changes in temperature, no condensation, few dust, no vibration,
and far from heat generators.
4. After turning off the system, wait at least 10 seconds before turning it on again.
Otherwise, failure may occur.
5. Before connecting/disconnecting the transducer, turn off the system or stop emitting
(freeze the image). Otherwise, the system or transducer may malfunction.
6. After using the transducer, remove the gel on it.
7. If the system is used in a small room, the room temperature may rise. Proper
ventilation must be provided.
8. Do not cover radiation holes on the system.
9. Only engineers of our company or authorized by our company can replace the fuses.
10. Only perform operations described in this manual.
11. Do not modify system parameters.
12. Deterioration of electrical and mechanical safety characteristics (such as generation of
a leakage current or deformation/abrasion of mechanical parts) and of image sensitivity
and precision may occur over a period of time. Check and maintain the system
periodically to ensure system performance.
13. To dispose of the system or any parts contact our Customer Care Department or your
local distributor first. Our company does not assume any responsibility for damage
resulting from disposal of the system without consulting our company.
