8.
Start
1.
2.
3.
4.
Install the heater in accordance with Chapter 6.
ATTENTION ! At the beginning of exploitation the small amount of
evaporating conservatives may occur. It will disappear in the process
of work.
Complete the electrical connection in accordance with the scheme (Chapter 7).
When the heater is ready for work turn the handle of the thermoregulator and choose
the necessary temperature.
The chosen temperature will be ensured within 30 minutes.
9.
Exploitation and technical support.
The heater generally doesn t need any service. To ensure its steady work it is
necessary to fulfill the following conditions (after the heater is switched off and
cool )
If necessary use a wet napkin to clean the frame and alcohol to clean the
heat-emitting plate.
Check the wire contacts and the stability of fixation (once a year).
! :
1.
2.
3.
Ensure proper isolation in the premises otherwise the work of the heater
will not be efficient due to cold air currents.
Heater exploitation conditions
:
•
-50°С до +
air temperature from
air humidity up
at
50°С;
•
80%
+25°С
10.
Possible disfunctions.
Possible
disfunctions
Ways of treatment
1.
The heater
does not give
enough warmth
•
2 0+ -
•
Check the voltages on the terminals it should be
Check the termoregulator
Compare the temperature on your thermometre with the chosen
temperature on the termoregulator. The difference must be +
3
/ 10V
/-2C
•
.
2.
The heater
does not work
•
•
•
•
•
Check the voltage
Check the intactness of the connecting wire
Check the contact of the heater
Check the contact in the power plug
Check the thermoregulator
Consult our dealers
11.
.
Storage
The heater should be stored in its original package in the premises with
fluctuation of temperature from
to
air humidity not more than
The heater should be safe from bangs, dust and moisture. The heat-emitting
plate must be treated very carefully. It can t be touched, in case of necessity
it can be cleaned with alcohol.
-50°С +50°С,
80%.
11
Summary of Contents for PION 04
Page 15: ...Notes ...
