12
Assembly Instructions
Fig. 1: Handlebar installation
In
stalling the Handlebars
The handlebar has two main parts--the bar and the stem. The Mammoth
handlebar has been removed for shipping, and must be attached in order to
ride. Position the bar in the center of the stem and ensure the correct position
by aligning the cross hairs printed on the bar (see the pictures in Figure 1
below). Also, the cross hairs will ensure that your grips are properly aligned
and in the correct postion and the angle of the bar is comfortable.
• Loosen the bolts to put handlebar in place
•
Use the reserved 4 bolts to install handlebar as shown in Figure 1
below
•
Adjust handlebar angle and fasten the 4 bolts one by one to 18-20
N.m. (see page 15 for general torque information)
•
Check that the forks and the handlebar are facing forward and
straight by standing at the front of the handlebar. Grip the front
wheel between your legs, hold the handlebar and adjust the
handlebar and the body of the cycle to form a 90 degree angle.
Summary of Contents for AWD MAMMOTH
