13
Fig. 3: Front Wheel
Install Front Wheel
• Most deliveries of the
Mammoth electric cycles will
arrive with the front wheel
mounted.
• In the rare case that it does not
come attached, put the front
wheel in the middle of the front
fork.
• Make sure the brake disc is
placed in the center of the
caliper gap and the front wheel
can rotate freely without any
noise. When the brake disc is
Fig. 2: Headlight
Install Headlight
•
The Mammoth headlight will come
installed, however, removal and
reinstallation can be done easily.
•
You can adjust the height and angle by
loosening the bolt and nut, making the
adjustment and then fastening the bolt
back.
•
Connect the light power cable by
connecting the cables identified with green
colour ends.
not in the gap, DO NOT pull the brake lever.
•
Install the front wheel and tighten the nuts provided. If your cycle
has a quick release, adjust and close tightly.
•
The fasten torque of the front wheel should be no less than 35-40
N.m. (no less than 35-40 N.m. for the rear wheel as well).
Headlight
Frame
Summary of Contents for AWD MAMMOTH
