ELECTRIC BICYCLE METER KT
—
LCD7 Product User Manual
- 32 -
if held
button (
SW
) long for about 2 seconds, all can exit the setting environment
and return to display 1, meanwhile, the current set parameters would be saved.
Under each parameter setting interface, if there’s no button operation on the meter for
more than 1 minute, and then the meter will automatically return to display 1, and the
original set parameters will be saved.
Parameter Copy
Set parameters (include general project parameter, P parameter and C parameter) of
all KT-LCD7 meter produced by our company according to requirements, and set the meter
to be a data source according to the method of
"C11 Attribute Selection Setting".
Use special wiring cables to properly wire to LCD7 meter needs to be copied
according to the diagram.
Meter parameter copy wiring diagram
Special wiring cable
Turn on meter power supply of data source. Power supply of 48V or 36V or 24V is
available (VB + positive power supply). After wiring the meter needs to be copied, hold
button long till meter is startup. Within 5 seconds after startup, hold
button
