32
DISPLAY
•
Check that the front and rear mechanisms are adjusted and
functioning properly, with the brake levers attached to the
handlebar. Make sure the shift levers and cables are properly
lubricated.
CABLES
• Look out for any loose cables. Make sure the male and female
plugs are properly connected.
•
There should be no strain on any wiring near the fork when
turning the handlebar from left to right.
•
Verify that the wiring on the frame is secure and free from any
moving parts that may damage the wiring. This includes any
wires and brake cable lines near the wheel or other moving parts.
KICKSTAND
•
Make sure that the kickstand is tightly secured, and not rubbing
against the ground or tires.
•
Do not sit on a cycle with a kickstand engaged.
STEERING
• Ensure that the handlebar and stem are correctly adjusted and
tightened, are set correctly in relation to the forks and direction
of travel, and allow for proper steering.
•
Check that the headset locking mechanism is properly adjusted
and tightened.
CHAIN, PEDALS, CRANKS & BEARING
• Ensure the chain is oiled, clean and runs smoothly (take extra
care in wet or dusty conditions).
•
Verify that the pedals are securely tightened to the crank. Check
headset, wheel bearings, pedal bearings and top and bottom
bracket bearings. Confirm the crank is not bent and is secure to
the axle.
•
Extra care is required in wet or dusty conditions.
FRAME AND FORK
•
Check that the frame and fork are not bent or broken. If either
are bent or broken, they must be replaced.
MOTOR DRIVE ASSEMBLY AND THROTTLE
• Ensure all motor drive components are correctly mounted and
functioning properly
Summary of Contents for OG BOBBER
