Operation and configuration
2 Local panel user interface
2.4 Configuration and parameter
setting
VM55.EN005
VAMP 24h support phone +358 (0)20 753 3264
27
pending. If no key is pressed, the auto-reset will be executed
within few seconds.
2.4.1.
Parameter setting
1.
Move to the setting state of the desired menu (for example
CONF/VOLTAGE SCALING) by pushing the ENTER key.
The Pick text appears in the upper-left part of the display.
2.
Enter the password associated with the configuration level
by pushing the INFO key and then using the arrow keys
and the ENTER key (default value is 0002). For more
information about the access levels, please refer to Chapter
2.2.5.
3.
Scroll through the parameters using the UP and DOWN
keys. A parameter can be set if the background color of the
line is black. If the parameter cannot be set the parameter
is framed.
4.
Select the desired parameter (for example Un) with the
ENTER key.
5.
Use the UP and DOWN keys to change a parameter value.
If the value contains more than one digit, use the LEFT and
RIGHT keys to shift from digit to digit, and the UP and
DOWN keys to change the digits.
6.
Push the ENTER key to accept a new value. If you want to
leave the parameter value unchanged, exit the edit state by
pushing the CANCEL key.
Figure 2.4.1-1.Changing parameters
