van Aaken SmartBox
™
C3.2
Chrysler Dodge RAM installation instructions
van Aaken Developments USA LLC
4990 Valenty Rd., Suite C
Chubbuck, ID 83202
Phone: (208) 234-5660 Fax: (208) 637-0287
Website: www.vanaaken.com Email: usa@vanaaken.com
There is a small groove (keyway) cut into the
threaded metal section of the switch. This groove
can be used to decide the orientation of the switch.
Power positions are:
•
Switch towards the keyway : Full power
position
•
Switch in the middle : Lower power position
•
Switch Away from the keyway : Unit is
turned off (no power gain)
5) Toggle Switch Installation and Connection
(Optional)
The supplied toggle switch may be installed in any suitable place
within the vehicle cab. The wires from the switch should be passed
through the bulkhead using a rubber grommet to seal the hole and
protect the wires.
Make sure that the switch wires cannot get entangled in any moving
parts behind the dashboard such as heating controls.
Connect the 2-pin plug on the switch loom to the remaining plug on
the main loom, which is located at the end nearest to the van Aaken
SmartBox
™
Secure the wires using the supplied cable ties.
Switch Operation
•
If
no switch is connected
to the van Aaken SmartBox
™
F
the default setting will be Power 2 – it will give
maximum extra power all the time.
•
If the included
3-position switch
is connected the unit can be switched between Off, Power 1 and Power 2.
Power 1 will typically give half the gain of Power 2 but this is entirely dependent on the tuning file programmed into
the unit. If in doubt about the function of each switch position please contact your SUPPLYING dealer.
4) Mounting the Unit
The unit should be mounted on top of the fuse box at the front
corner of the engine bay.
Fix the unit in place using the supplied self adhesive Velcro. The
area on the vehicle where the unit is to be attached should be
thoroughly cleaned first to remove all traces of oil, engine
lacquer or dirt.
The black 12-pin plug on the van Aaken SmartBox
™
C3.2
loom
should be led over to the unit and firmly connected to the plug
on the van Aaken SmartBox
™
C3.2
unit so that both catches on
the sides of the plug are seated into place.
The wire should be secured with cable ties so that it cannot
touch any hot, moving or sharp objects in the engine bay.
