1 1/
2”
4
Place rail
L
alongside right bracket
K
with 5/16” hole to front
of brake. Slide hex head portion of screw
C
down track and
extend through 2nd hole from end of bracket
K
as shown (see
center arrow). Start knob
E
onto threads and leave loose for now.
Repeat this procedure with remaining rail
L
and left bracket
J
.
5
Align front hole in rail
L
with front hole in bracket
K
. Insert
Fast Pin
A
through front hole in rail, then through bracket.
Repeat this procedure with remaining rail
L
and bracket
J
.
6
Start knob
E
2 or 3 turns onto the threads of a hex head screw
C
.
Slide hex head portion of screw into track of rail
L
1 ½” and leave
loose. Repeat this procedure with remaining rail
L
.
7
Ensure left & right rails
L
are 34 ¼” apart to receive the slotted
brackets on bottom of tool. After aligning the slots with knob
threads, slide tool onto rails until slotted brackets are
FLUSH
with
ends of both rails (see Detail F). Tighten knobs on both sides.
Ensure rails and brackets are positioned squarely on brake then
tighten all fasteners, knobs
E
and locknuts
G
securely in place.
Check all fasteners and knobs often and tighten as needed.
8
Install the roller handle over the handle plugs and insert
short fast pins
B
through holes. Reverse procedure to remove
handles when tool is being stored or transported.
9
To install the bending leaf handle, align holes in ends of tube
with holes in handle plugs. Insert short fast pins
B
as shown.
Flush
Flush
Mounting
Rail Track L
Bracket
K
Brake
Rail Track
I
Slide two hex head screws
C
into tracks in bottom of brake
rail. Extend bracket
K
over screw threads and tighten with
knobs
E
. Ensure bracket
K
is
FLUSH
as shown. Slide two hex
screws
C
into mounting rail track
L
and through holes in
bracket
K
. Tighten firmly with lock nuts
G
. Repeat procedure
on opposite side of brake facing away. Note: Use illustration
below for assistance.
2
Start a knob
E
onto a hex screw
C
and slide into mounting
rail track approximately 2 inches. Loosen slotted brackets
from under tool and slide even with mounting rails keeping
tool centered between the mounting rails. Slide the slotted
brackets over the screws until
FLUSH
with mounting rails. Tight-
en knobs
E
securely. Now tighten lock nuts
G
. To remove tool,
loosen knobs
E
and slide off from mounting rails.
3
Firmly tighten all knobs
E
and lock nuts
G
. Install the rolling handle and the bending leaf handle to complete the setup of the tool. Check the tool often for looseness and tighten as needed. Make sure
the tool is free from dirt and debris which can damage tool and mar material. Do not lean against tool as tipping or damage can occur. Do not use the reinforcement clip when working with standard
trim coil. Refer to step 4 Forming Gutter-Hood for instructions on using the reinforcement clip to make hood from stiffer gutter-coil material. Note: Except for the special instructions seen above for mount-
ing Trim-A-Gutter™ to the wider 20" throat brakes, all other instructions should be followed.
Track
Slotted
brackets go outside of rails
Detail F
Go online or click the link below for
additional Instructions, Tips and How To’s
http://www.van-mark.com/Roofing/TrimAGutt/tag_over.html
Remove tool before moving
or transporting around job.
