14
1.10.2 Overloading clutch P.T.O. shaft (Option)
To ensure correct functioning, friction clutches must be relieved prior to first time use and after lengthy periods of non-
use. To this end, the friction linings must be relieved of pressure and the clutch turned manually.
Notes on relieving of Type K96:
•
Uniformly tighten the nuts No. 3, thereby relieving the pressure on the friction disks.
•
Turn the clutch.
•
Subsequently unscrew the nuts No. 4 again up to the end of the thread.
1.10.3 Bearing houses / rotor shaft
To be lubricate every 8 hours of operation.
1.10.4 Rear roller
To be lubricate every 8 hours of operation
1.10.5 3-Point headstock
The 3-Point headstock has parallelogram arms for side offset and parallelogram arms for bottom following, must be
lubricated at least every 8 operating hours.