AIR N ARC
®
150 SERIES
SECTION 5: MAINTENANCE
090051-OP_r0 (FEB-2014)
PAGE - 39
Vanair Manufacturing, Inc.
vanair.com • 800-526-8817
1. Remove the bolt [
A
] and washer
[
B
] from the rear-side of the
engine ignition housing [
C
].
2. Locate the fuse housing and
open the cap to expose the fuse.
3. Remove the blown fuse [
E
], and
replace with new fuse.
4. Replace the fuse housing cap to
secure the fuse.
5. Replace the rear-side ignition
housing onto the front-side
ignition housing [
C
].
6. Secure into place with the
washer and bolt.
5.6 STORAGE AND
INTERMITTENT USE
5.6.1 INTERMITTENT USE
If the unit is not used very regularly always
treat the fuel with a fuel stabilizer.
Check all belts and hoses for signs of
deterioration such as visible surface cracks,
stiffness or discoloration.
5.6.2 LONG TERM STORAGE
Disconnect the battery cable that is
connected to the positive (+) side of the
battery.
Depressurize the air tank and open the drain
valve on the tank.
Cover the unit with a tarp or plastic to
prevent the accumulation of dust, but leave
the bottom open for air circulation.
Fill gas tank with fuel and fuel stabilizer to
prevent moisture build-up in the tank.
KEY
DESCRIPTION
A
BOLT
B
WASHER
C
ENGINE IGNITION HOUSING - REAR
D
FUSE HOUSING
E
FUSE, 25 A
F
ENGINE IGNITION HOUSING - FRONT
G
ENGINE KEY STARTER (location reference)
Figure 5-8: Fuse Location
A
B
C
E
D
F
G
