www.vanco1.com
800.626.6445
5
PANEL DESCRIPTIONS
1
2
3
4
5
6
1. Mini-USB port : Connect to a PC for software operation
2. HDMI IN : Connects to an HDMI source with an HDMI male-male cable
3.
EDID MODE : Setting desired EDID mode
4. 5V DC: Connect to 5V power supply unit
5.
LED INDICATOR: [red]: power indicator LED [green]: signal indicator LED
6. HDMI OUT : Connect to an HDMI display with an HDMI male-male cable.
0 - EDID Full-HD(1080p@60) - 24bit 2D video & 7.1ch audio
1 - EDID Full-HD(1080p@60) - 24bit 2D video & 2ch audio
2 - EDID Full-HD(1080p@60) - 36bit 2D video & 7.1ch audio
3 - EDID Full-HD(1080p@60) - 36bit 2D video & 2ch audio
4 - EDID HD(1080p@30)(1080i@60)(720p@60) - 24bit 2D video & 7.1ch audio
5 - EDID HD(1080p@30)(1080i@60)(720p@60) - 24bit 2D video & 2ch audio
6 = [Manual Mode] – Learning EDID from HDMI output manually
7 = [Serial Command Mode] – Software can access EVRC5002 only in this mode
To avoid any errors during switching between modes (i.e. changing from Recording mode to Connection mode
might overwrite the EDID of the display in the EDID Reader/Writer/Re-timer by the default EDID), UNPLUG
the power supply unit before changing one of the above modes. Plug in the power supply unit after the pin
position of the DIP switch has been adjusted.
*The EDID Reader/Writer/Re-timer may not work on monitors or displays with EDID write-protection.
Caution! Do not plug HDMI cable into Source-HDMI connector when
adjustments are being made from one operation mode to another.