Configuration
© Vanderbilt 2016
39
9.4
Alarm
9.4.1
Alarm
If a sensor or another device is connected to the alarm input, an alarm will be
triggered when an event is detected by the sensor or the other device. For ex-
ample, if a sensor is attached to a door, an alarm will be triggered each time
the door is opened. An enabled motion sensor will trigger an alarm a change
on a screen is detected.
On the rear panel, there are 3 digital alarm inputs (AL1, AL2, and AL3). Before
using the alarm function, you need to define some parameters.
External digital input 1, 2
1.
Alarm Input
When "Alarm Input" is selected: external alarm will be detected.
The following functions will be enabled when the option "Alarm Input" is
selected. B/W Mode: The camera is switched to monochrome mode when
a trigger signal is received.
2.
Input Type
Normally Open (NO): open if nothing occurs but closed in case of an
alarm. Normally Closed (NC): closed if nothing occurs but open in case of
an alarm.
3.
Text Enable
When "ON" is selected, an alarm message will be displayed on the screen.
Summary of Contents for CFMW3025
