V&P Scientific VP 767-5A Series Technical Notes Download

Page: 1 / 6

V&P Scientific, Inc.

Technical Note 083B

Technical Note 083B

CARE AND USE OF 12 CHANNEL DIRECT DRIVE BUBBLE PADDLE RESERVOIR

Motor Control Unit VP 767-5A with VP 758-5 Series Direct Drive Bubble Paddle Reservoirs:

VP 758-5PP, VP 758-5PTFE

Figure 1. The Direct Drive Bubble Paddle Reservoir System is composed of a VP 767-5A Motor

Control Unit and a VP 758-5 series Bubble Paddle Reservoir. VP 767-5A includes

Motor Base, Control, and Power Supply as shown above.

VP 767-5A

MOTOR BASE and CONTROL, Single Coupling from Motor to Sealed Bearing Shaft, Black

ABS Enclosure, DC Motor, 120/220 Volts, 50/60 Hz, CE Compliant, Mates to VP 758-5 Series Bubble
Paddle Reservoirs

VP 758-5PP

BUBBLE PADDLE RESERVOIR, Sealed Bearing Shaft Powered, 8 or 12 Channel,

Polypropylene Reservoir, Sculpted Bottom, with 1 Bubble Paddle, 13 Bubbles/Paddle, Black Anodized
Aluminum, Mates to VP 767-5A, Mixes 450 mL

VP 758-5PTFE

BUBBLE PADDLE RESERVOIR, Sealed Bearing Shaft Powered, 8 or 12 Channel, PTFE

Reservoir, Sculpted Bottom, with 1 Bubble Paddle, 13 Bubbles/Paddle, Black Anodized Aluminum,
Mates to VP 767-5A, Mixes 450 mL

VP 758-5PP

Reservoir

VP 767-5A

Motor Control Unit

Power
Supply

Control

Motor
Base

Summary of Contents for VP 767-5A Series






