1.
Position and dry fit the unit in place to check the positions of all units relative to van
2.
Hint -
it’s a good idea to mark the positions with masking tape
3.
Mark the fixing holes through the slots in the base of the unit
4.
Drill holes
5.
Pass power cable through the slots in the base
6.
Re position unit and fix with hex bolts
7.
Or use the anchor cleat option to fit to rail system i.e. VW Caravelle, California Beach etc
8.
Anchor cleats for the VW rail system slide into the rail through plastic caps at the end of the
rails.
Kombi Pod
●
These units use the Campingaz R904 or R907. The gas regulator and jubilee clip have been
included.
●
The gas tray has been left loose as you will need to figure out which part of the mounting
slot to use before screwing down the tray. x3 screws have been included
–
2 to go through
the belt bracket and one more to secure down the tray).
●
The 12v lead can be passed through the hole in the base of the unit.
●
For instructions on the hobs please refer to the included instruction manuals.
●
Due to the numerous positionings of the units there may be the need for drilling an
additional in the plywood base of the unit.
Maxi Pod
●
These units use the Campingaz R904 or R907. The gas regulator and jubilee clip have been
included.
●
The 12v lead can be passed through the hole in the base of the unit.
●
For instructions on the hobs please refer to the included instruction manuals.
●
Due to the numerous positionings of the units there may be the need for drilling an
additional in the plywood base of the unit.
Fridge Pod
●
These units use the Campingaz R904 or R907. The gas regulator and jubilee clip have been
included.
•
The 12v lead and optional external waste can be fed through the rear of the pod
•
If you are installing the pod onto a rail system/seat brackets then a shorter bolt and smaller
nut has been included to fit under the fridge.
•
For instructions on the hobs please refer to the included instruction manuals.
•
Due to the numerous positionings of the units there may be the need for drilling an
additional in the plywood base of the unit.
Find us at:
Email: info@vangear.co.uk
Tel: 01444 247129 Mobile: 07810 592353
www.facebook.com/Vangearcampervanunits
Design registered and copyrighted at Intellectual Property Office
