CT-6500 Series 2 Operating Instructions
42
9.5 Printing Timing Test Record Directory Stored in the EEPROM
The user can obtain a timing-record directory that was stored in the CT-6500’s FLASH
EEPROM by using the steps in Table 10.0.
Table 10.0 Print Timing Test Record Directory
STEP
OPERATION
ACTION
DISPLAY
1
SELECT SETUP MENU.
PRESS #3 KEY.
1.ANALYSIS POINT
2.MEASUREMENT UNITS
3.SAVE / RESTORE
4.NEXT PAGE
2
SELECT SAVE/RESTORE MENU.
PRESS #3 KEY.
1.SAVE SHOT
2.RESTORE SHOT
3.SHOT DIRECTORY
4.ERASE SHOT
3
SELECT SHORT DIRECTORY.
PRESS # 3 KEY.
1.SHORT DIRECTORY
2.FULL DIRECTORY
"STOP" TO QUIT
4
SELECT SHORT DIRECTORY.
PRESS #1 KEY.
PRINTING ABBREVIATED
DIRECTORY
“STOP” TO QUIT
5
RETURN TO MAIN MENU.
NO ACTION.
1.RUN TEST 06/10/07
2.GET RESULTS 20:10:01
3.SETUP
4.DIAGNOSTIC
NOTE
1. If the "Short Directory" was selected, the CT-6500 will print out the shot
identifications of the last ten timing shots stored in the EEPROM.
2. If the "Full Directory" was selected, the CT-6500 will print out the shot
identifications of all the timing shots stored in the EEPROM.
3. A typical shot directory printout is shown on in Figure 17.0.
Summary of Contents for CT-6500 2 Series
Page 22: ...CT 6500 Series 2 Operating Instructions 21 Figure 4 0 Series Contact Cable Connection...
Page 77: ...CT 6500 Series 2 Operating Instructions 76 APPENDIX F SIEMENS TCP Breaker Velocity Calculation...
Page 79: ...CT 6500 Series 2 Operating Instructions 78 APPENDIX H CT 6500 SIEMENS SPS2 Test Plan...
Page 82: ...www vanguard instruments com...
