WRM-10P AND WRM-40 USER’S MANUAL
REV 3
i
SAFETY SUMMARY
NOTICE
This manual applies to both the WRM-10P and WRM-40 transformer winding resistance
meters. The operating procedures are virtually the same for both models, and any differences
are clearly described where applicable.
FOLLOW EXACT OPERATING PROCEDURES
Any deviation from the procedures described in this User’s Manual may create one or more
safety hazards, may damage the WRM-10P/40, damage the test transformer, or cause errors in
the test results. Vanguard Instruments Company, Inc. assumes no liability for unsafe or
improper use of the WRM-10P/40.
All safety precautions provided in this manual must be observed during all phases of testing
including test preparation, test lead connection, actual testing, and test lead disconnection.
SAFETY WARNING AND CAUTIONS
The WRM-10P/40 shall be used only by
trained operators
. All transformers under test shall be
off-line
and
fully isolated
.
DO NOT MODIFY TEST EQUIPMENT
To avoid the risk of introducing additional or unknown hazards, do not install substitute parts or
perform any unauthorized modification to any WRM-10P/40 test unit. To ensure that all
designed safety features are maintained, it is highly recommended that repairs be performed
only by Vanguard Instruments Company factory personnel or by an authorized repair service
provider. Unauthorized modifications can cause safety hazards and will void the manufacturer’s
warranty.
WARNING
Do not remove test leads during a test. Failure to heed this warning can result in lethal
electrical shock to personnel and damage to the equipment.
