VANNER
Incorporated
Owners Manual
Max Battery Charger
P
age 6
Owner’s Manual
2.1 General Precautions
Do not expose the charger to direct water spray or snow.
To reduce the risk of a fire hazard, do not cover or obstruct the ventilation openings.
Do not install the charger in a zero clearance compartment. This may result in
overheating or diminished performance.
To avoid the risk of fire, electrical shock, or injury to persons, do not use
attachments not recommended or sold by the Vanner Inc.
Vanner recommends that all AC and DC electrical wiring be performed by a licensed
electrician or a qualified technician to ensure compliance with all applicable national and local
wiring regulations.
To avoid a risk of fire and/or electrical shock, always verify wiring
connections are in good electrical condition. All external conductors must use proper wire
size to avoid dangerous overheating or diminished performance.
If the charger has been dropped or damaged in any way, do not operate the charger
until it has been verified to be safe by a qualified technician.
To reduce the risk of electrical shock, always disconnect the AC and DC connections
to the charger before attempting any maintenance. Simply turning the charger off does not
prevent electrical shock.
The charger must be properly grounded in accordance with local and national codes
and ordinances before operation. For most installations, the negative (ground) conductor
should be bonded to the grounding system at one and only one point in the system.
For optimum charger performance, battery temperature should be above 32 degrees
Fahrenheit.
Do not disassemble the charger. See the service section of this manual for
instructions on obtaining service. Attempting to service the inverter yourself may result in a
risk of electrical shock, fire and/or loss of warranty.
