19
User manual
Tandems 14.10
Twinny Plus and Kivo tricycle:
Charging the Battery:
For the best performance and to prolong the
life of the battery, we recommend that you
charge the battery at home at room
temperature.
To charge the battery:
1. Open the little lock by turning the key a
quarter (to the right)
2. Push down the lock while pulling the
battery with your other hand.
3. Take the battery pack into the house. Plug
the charger into the plug contact of the
battery.
4. Connect the charger plug into the socket.
Turn the switch [A] ‘on’. A green LED light
on the charger will start to blink fast.
Beware!
If the battery is not
connected properly, the green LED
light blinks fast.
5. Depending on the battery level, the
charging time is about 4 hours. If the
green LED light stays on, the battery is
fully charged.
6. Once the battery is charged, pull the plug
from the socket first.
7. Then pull the connector from the battery.
8. Put the battery back in the holder of the
cycle and close the lock.
It is also possible to charge the battery while it
is still in the holder.
When charging the battery, first
connect the charging point and
then insert the plug into the socket!
After being charged, first
disconnect the socket and only
then remove the charger from the
tricycle!
If a red LED light on the charger starts blinking, remove the plug from the
socket and don’t use the charger any more. Contact your dealer.
3.
4.
[A]
1.
2.
