www.fmiproducts.com
125525-01E
25
INSTALLATION
Continued
EMBER PLACEMENT - BGE SERIES
BURNER SYSTEMS
WARNING: Do not use any
other ember material not sup
-
plied with this unit.
WARNING: Do not operate
unit without ember material
correctly in place as shown in
Figures 51 & 52. Do NOT place
ember material anywhere else
on the unit. Use only ember ma
-
terial supplied with unit. Exces
-
sive or incorrectly placed ember
material may produce carbon
monoxide or soot.
1.
Ember Chunk Placement.
The
BGE2436 burner systems include three
ember chunks that are designed to fit
over shoulder screws on the ember pan
burner. The bottom of each ember chunk
has a hole for securing the ember chunk
in place when it is placed over a shoulder
screw. Place the ember chunks as shown
in Figure 50 on page 26 by placing the
ember chunk with the number "1" on
the left, "2" in the center, and "3" on the
right. These numbers are embossed on
the back of each piece for identification
purposes. Please note that BGE18 burner
systems do not include ember chunks.
11. Rest the middle crossover log (18" D-070,
24" & 30" D-044) onto the right middle log
and the left front log (see Figure 48). Make
sure to match the projection on the bottom
of the crossover log with the recess area in
the right middle log and the left front log.
Figure 48 - Installing Middle Crossover Log
Figure 49 - Installing Top Rear Log
Top Rear
Log
Rear Log
Middle
Crossover
Log
12. Place the top rear log (18" D-071, 24" &
30" D-045) onto the rear log as shown. The
rear log has a projection that will fit into the
recess area on the bottom of the top rear
log (see Figure 49).
