www.fmiproducts.com
125527-01A
18
iNStallatioN
Continued
FIBER LOG MODELS
LBG(18,24,30,36)-SM
Note: Your appliance may vary from model
shown but log placement will be the same.
1. Place bottom log in center of the base as-
sembly as shown in Figure 19.
2. Rest rear log in back corner sections of
base assembly as shown in Figure 19.
Make sure log is completely vertical and
not leaning in toward burner where flame
will touch the log.
3. Position front right log against right side
of grate prongs (see Figure 19).
4. Position front left log against left side of
grate prongs (see Figure 19).
Rear Log
Grate
Prongs
Figure 19 - Installing Log Set
Bottom Log
Base Assembly
Front
Right Log
Front Left
Log
Figure 20 - Installing Log Sets
Middle Right Log
Middle
Left Log
Bottom
Log
Pin on Front
Left Log
Figure 21 - Installing LBG36-SM Model
Control Cover Logs
Left Control
Cover Log
Right Control
Cover Log
Right Small Front Log
Left Small
Front Log
Bracket
Bracket
5. Place middle right log over front right and
bottom logs as shown in Figure 20. Be
sure hole in middle right log seats over
pin in bottom log.
6. Place middle left log over front left and
bottom logs as show in Figure 20. Be
sure hole in middle left log seats over pin
in front left log.
7. For LBG36-SM, the front right and left
logs are longer and are supported with
brackets on each end (see Figure 21).
Place left and right small front logs
under left bracket and beside right
bracket.
8. For LBG36-SM, position left and right
control cover logs as shown in Figure
22, page 19. These may be placed as
desired to hide controls.
