www.fmiproducts.com
125527-01A
25
oPeratioN
Continued
HAND-HELD
REMOTE OPERATION
BATTERIES
WARNING: Make sure your
selector switch is in OFF posi-
tion before installing or chang-
ing batteries in your hand-held
remote or receiver.
For installing or replacing batteries in remote
control or receiver, see
Installing Batteries in
Remote Control and Receiver
on page 22.
Program receiver to remote
on page 27
Low Battery - Hand-Held Remote Control
When batteries in hand-held remote control
are low, an icon will appear on display.
Low Battery - Remote Receiver
When batteries in receiver are low, no acoustic
signal will be given when ON/OFF button is
pressed. If batteries in receiver are low, fireplace
can be switched on manually by moving remote
selector switch to ON (see Figure 38).
ON
Figure 38 - Low Battery Display
FAHRENHEIT/CELSIUS INDICATOR
You can set your hand-held remote control to
display the temperature in either Fahrenheit
or Celsius. With remote control off, press
Thermostat button and Mode button at the
same time. This will toggle the display from
°F to °C.
Figure 39 - Remote Control Display
Fahrenheit to Celsius
Figure 40 - Hand-Held Remote Control
ON/OFF
MODE
UP/ DOWN
Arrows
THERMOSTAT
LCD
Display
OPERATING REMOTE CONTROL
WARNING: Fireplace can
turn on suddenly. Keep away
from burner.
After lighting pilot, let pilot flame burn for about
one minute. Slide remote selector switch to
REMOTE position. You can now turn burner
on and off with remote.
IMPORTANT:
Do not leave selector switch in
REMOTE or ON position when pilot is not lit.
This will drain batteries.
When any button is pushed on remote control,
LCD display will glow blue. Blue glow will go
off after several seconds if no action is being
taken with remote.
ON/OFF
Push ON/OFF button and burners will come
on in high position (see Figure 40). An
acoustic signal from the receiver confirms
the command.
Push ON/OFF button again and burners will
turn off. A beep from receiver confirms the
command.