www.fmiproducts.com
125527-01A
26
oPeratioN
Continued
FLAME HEIGHT
This function allows you to control the height
of flames through 5 levels (see Figure 42).
Select the manual flame height function by
pressing the MODE button until a flame is
shown in the lower left corner of the display.
Use UP/DOWN arrow button to set desired
flame height for front and rear burner (see
Figure 42). A beep from receiver confirms the
command. When the flame height is set to it’s
lowest level it is possible to turn the unit OFF
by pressing the DOWN arrow button again.
If this occurs press the UP arrow button to
relight the unit. A beep from receiver confirms
the command.
ON
ON
MAX
Figure 42 - Remote Control Display of
Flame Height Minimum and Maximum
MINIMUM
MAXIMUM
ON
Figure 43 - Room Temperature Setting
Room
Temperature
Set
Temperature
ROOM THERMOSTAT
The remote control can operate as a room
thermostat. The thermostat can be set to a
desired temperature to control the comfort
level in the room.
To activate, press THERMOSTAT button on
remote control (see Figure 40, page 25). The
word ON will appear to the right of tempera-
ture bulb graphic on display (see Figure 43).
Use UP/DOWN arrow button to set desired
room temperature. Control system will cycle
fireplace on or off to maintain selected tem-
perature.
ON
ON
Figure 41 - On/Off Setting
