www.fmiproducts.com
125784-01D
19
INSTALLATION
Continued
FIBER LOG MODELS
LBG(18,24,30,36)-SM
Note: Your appliance may vary from model
shown but log placement will be the same.
1. Place bottom log in center of the base as-
sembly as shown in Figure 29.
2. Rest rear log in back corner sections of
base assembly as shown in Figure 29.
Make sure log is completely vertical and
not leaning in toward burner where flame
will touch the log.
3. Position front right log against right side of
grate prongs (see Figure 29).
4. Position front left log against left side of
grate prongs (see Figure 29).
Rear Log
Grate
Prongs
Figure 29 - Installing Log Set
Bottom Log
Base Assembly
Front
Right Log
Front Left
Log
Figure 30 - Installing Log Sets
Middle Right Log
Middle
Left Log
Bottom
Log
Pin on Front
Left Log
5. Place middle right log over front right and
bottom logs as shown in Figure 30. Be sure
hole in middle right log seats over pin in bot-
tom log.
6. Place middle left log over front left and bottom
logs as show in Figure 30. Be sure hole in
middle left log seats over pin in front left log.
7. For LTF36-SM, the front right and left
logs are longer and are supported with
brackets on each end (see Figure 31,
page 20). Place left and right small front
logs under left bracket and beside right
bracket.
8. For LBG36-SM, position left and right
control cover logs as shown in Figure
32, page 20. These may be placed as
desired to hide controls.
Figure 28 - Installing Log Support Brackets
Left Log
Support
Bracket
Chassis
Right Log
Support
Bracket
Right Front of Chassis
