www.fmiproducts.com
125784-01D
20
INSTALLATION
Continued
LBG(18,24,30)-SM MODELS
LBG36-SM MODELS
Figure 32 - Correct Log Placement
CONCRETE LOG MODELS
LBG(18,24,30)-RM
Each log is marked with a number. These
numbers will help you identify the log when
installing (see chart on page 21). It is very
important to install these logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater.
Note: Your appliance may vary from model
shown but log placement will be the same.
1. Place fiber ramp-log in center on chassis
as shown in Figure 33. The fiber ramp-log
can be identified by its shape and much
lighter weight when compared to the other
logs.
Figure 33 - Installing Log Set
Base Assembly
Ramp Log
Figure 34 - Installing Log Set
Ramp
Log
Metal Tab
2. The log must sit flat on the black sheet
metal and behind the left metal tab as
shown in Figure 34.
3. Place front left and right logs and rear log
as shown in Figure 35.
4. Place top left log as shown in Figure 36,
page 21. The bottom of the log is shaped
to fit onto the recessed areas of the front
left log and the rear log. The recessed
areas are painted yellow.
5. Place top right log as shown in Figure 36,
page 21. The bottom of the log is shaped
to fit onto the recessed areas of the front
right log and the rear log. The recessed
areas are painted yellow.
Rear Log
Front Right Log
Front Left Log
Figure 35 - Installing Logs
Figure 31 - Installing LBG36-SM Model
Control Cover Logs
Left Control
Cover Log
Right Control
Cover Log
Right Small Front Log
Left Small
Front Log
Bracket
Bracket
