www.fmiproducts.com
125784-01D
26
EMBER PLACEMENT - BGE SERIES
BURNER SYSTEMS
WARNING: Do not use any
other ember material not sup
-
plied with this unit.
WARNING: Do not operate
unit without ember material
correctly in place as shown in
Figures 60 & 61. Do NOT place
ember material anywhere else
on the unit. Use only ember ma
-
terial supplied with unit. Exces
-
sive or incorrectly placed ember
material may produce carbon
monoxide or soot.
1.
Ember Chunk Placement.
The
BGE2436 burner systems include three
ember chunks that are designed to fit
over shoulder screws on the ember pan
burner. The bottom of each ember chunk
has a hole for securing the ember chunk
in place when it is placed over a shoulder
screw. Place the ember chunks as shown
in Figure 59 on page 27 by placing the
ember chunk with the number "1" on
the left, "2" in the center, and "3" on the
right. These numbers are embossed on
the back of each piece for identification
purposes. Please note that BGE18 burner
systems do not include ember chunks.
11. Rest the middle crossover log onto the right
middle log and the left front log (see Figure
57). Make sure to match the projection on
the bottom of the crossover log with the
recess area in the right middle log and the
left front log.
12. Place the top rear log onto the rear log as
shown. The rear log has a projection that
will fit into the recess area on the bottom
of the top rear log (see Figure 58).
INSTALLATION
Continued
Figure 56 - Installing Left Top Log
Figure 57 - Installing Middle Crossover Log
Figure 58 - Installing Top Rear Log
Rear Log
Left Top Log
Left
Middle
Log
Top Rear
Log
Rear Log
Middle
Crossover
Log
10. Place the left top log onto the rear log and
the left middle log. Make sure to place the
projection on the bottom of the left top log
into the recessed areas on the rear and left
middle logs (see Figure 56).
