SECTION 8 – Design Center Guide
850D-DA
850D-DA Digital Distributed Audio Amplifier
Installation Manual
41316 / 1308134-A © 2011
Page
17
In the
Object Editor
, the 850D-DA Audio Stack 1 is initially
displayed as shown below.
Object Editor | 850D-DA Initial Tree
Zone Editor With Common Controls, Audio Levels, etc.
Common Settings
Source – the zone’s selected source. Notice the left and right
arrows
allowing the previous or next source to be
selected/assigned with all of the same common controls.
Zone, Common Controls
Audio Levels
Click the Audio Levels tab for direct control / setup of the
following as illustrated for each zone.
Zone, Audio Levels
Preset Editor With Page 1 and 2 Setup
Presets allow predetermined programmed levels at the touch
of a button. These include pre-selection of sources, zones,
Common Settings in each zone, Audio Levels in each zone and
may even be assigned to an alarm. Presets are not temporary
settings but pre-programmed settings. When a Preset is
pressed, pressing it again does not return all settings to their
previous status. Keep this in mind when setting up Presets.
Pages are different than Presets, because they do return all
settings to their previous status when the Page call is over.
Page calls are typically activated from dry-contacts often used
for alerts as in a door bell.
Page 1 Settings Example
Steps to Setup a Preset or Page
1.
In Design Center’s Object Editor, select the Preset to
program – 1-14.
2.
Click on
Learn Zone Settings
– notice the red
button appears in the Object Editor.
3.
Click on the
Zones
tab and place a check mark in each
Zone wanted in the Preset program.
4.
If the Preset is to be tied to an alarm, click on the
Alarm
tab and setup the alarm parameters and click the Enable
button.
Summary of Contents for EQ40TB-TI
Page 7: ...Digital Distributed Audio Amplifier Instruction Manual 850D DA...
Page 8: ......
Page 38: ......
