C
hapter 5 >> Main Menu
25
English
Positioner
1 This function is used when receiving DiSEqC 1.2 Command with the adaptor that
controls positioner antenna. Select a satellite using the
Arrow (
▲/▼
)
buttons and
press the
OK
button. Satellite list appears.
On the satellite list, you can select satellites
pressing the OK button. Press the
RED
(Last)
button to save the selected satellites.
2
If you press the
YELLOW (Audio)
button, on-
screen navigation menu is highlighted. Use
the
Arrow (
▲/▼/◄/►
)
buttons to move the
motor to the west, east, north, and south in
order. Position of the motor can be restricted
to the software setting limits (West/East)
using the
RED / BLUE
buttons.
3
Press the
OK
button on the
Go to satellite
menu. Dish changes its position to the
direction of satellite.
4
Press the
OK
button on the
Save Current Position
menu. Current position of the
motor is saved according to the selected satellite.
5
Press the
OK
button on the
Go to Ref. Position
menu. Motor changes its position to
the zero longitude/latitude where the count begins. (this function is not supported by
the adaptor that controls positioner antenna)
6
Go to Reference
changes the position of control adaptor.
7
Reset Positioner
initializes the position of motor to the default value.
8
You can change the function Menu (Go to Ref. Position / Reset Position / Calculate
Positions) by using the Arrow (◄/►) button, activate the function with OK button
-
Go to Ref. Position: changed position of the motor also applies to the directions for
other satellites.
-
Calculate Positions: Confirm the
Enable Limits/Disable
Limits
function pressing
the
OK
button. This function may not be supported depending on the model.
9
The method to position motor is selected on the
Continuous / Step (Impulses) / Time
(Seconds)
menu, If you press the
Arrow (
◄/►
)
button once on the
Continuous
mode,
selected TP signal of the satellite is locked or the motor stops to move.
On the
Step (Impulses)
mode, you can select steps (pulse) from 1 to 10. The
motor changes its position according to the selected step if moved to the left or right
(depending on the motor).
On the
Time (Seconds)
mode, you can select time (seconds) from 1 to20. the
motor changes its position according to the selected step if moved to the left or right
(Depending on the motor).
If you have a MOTEK motor please use positioned menu instead of DiSEqC 1.2. to make
sure that your motor is working correct.
Installation
Summary of Contents for HD 8000S
