5. Installation:
Installation
6
NexStar 3 SuperSpeed USB 3.0 External 3.5” HDD Enclosure:
Preparing the hard drive:
(1)
Preparing the NexStar 3:
( figure 5.1-A )
5.1. Hardware Installation:
( figure 5.1-A )
If there are jumper settings on the hard
drive, please set the hard drive jumpers to
MASTER or SINGLE DRIVE ONLY. Please
refer to the manufacturer's documentation
of your hard drive for further information
on your jumper settings.
Remove the side of the NexStar 3
SuperSpeed with the power and USB
connection ports. If it has previously been
screwed in place, remove the screws first.
Carefully slide out the hard drive caddy for
approximately 3 inches.
Unplug the red and white cable for the LED.
You may slide out the hard drive caddy.
(1)
(2)
(3)
(4)
