Vantron
| Embedded in your success, Embedded in your better life
World-leading provider of embedded/IoT products and solutions
C335 Series Edge Computing Gateways | User Manual
24
├
── build.date
//Image built date
├
── sd2emmc.sh
//Script for SD card bootup
├
── XOS_sd2mmc_VT
-M2M-C335S_Vxxxxxxx.Fxxxxxxx.img //Bootup image
├
── XOS_sd2mmc&sdAutoUpgrade_VT
-M2M-C335S_ Vxxxxxxx.Fxxxxxxx.sha256sum
//sha256sum file
└── XOS_sdAutoUpgrade_VT
-M2M-C335S_ Vxxxxxxx.Fxxxxxxx.img.gz //Upgrade image
4)
Run the following command with root account to make a bootable SD card:
~# sudo ./sd2emmc.sh
/dev/sdb
Replace /dev/sdb with the correct SD card path.
Removal of the SD card before a completion message pops up will cause the process
to fail.
Remove the SD card and run the command again in case the making process fails.
4.
Insert the SD card to the slot;
5.
Power the Gateway on. After the system boots up, the status indicator will turn solid
green and eMMC flashing finishes.
1.8.2
System boot from eMMC flash
1.
Open the Gateway enclosure;
2.
Set DIP switch S1 to
on:on:off:on
as shown below;
3.
Power the Gateway on. After the system boots up from eMMC, the status indicator
will turn solid green.
C335S for illustration
