Vantron
| Embedded in your success, Embedded in your better life
World-leading provider of embedded/IoT products and solutions
C335 Series Edge Computing Gateways | User Manual
41
3.3.4
WAN Setting – 4G/LTE
Before you configure for 4G/LTE connection, make sure you have inserted the activated
SIM card in the slot
and the LTE antennas are installed. Refer to
settings.
4G/LTE:
ETH0
,
ETH1
and
WiFi AP
are bounded with the network bridge (br-lan). Normally,
if the Gateway is using a common 4G module, the device port for 4G/LTE communication
displayed under the protocol will be “3g-4g” which is the WAN port. When using a carrier
pre-certified 4G module provided by Vantron, the device port for 4G/LTE communication
displayed under the protocol will be “eth2” which is the WAN port.
4G/LTE
setup procedures:
Step 1: Select
4G/LTE
for
WAN Protocol
;
Step 2: Click to switch the protocol to
4G/LTE
;
Step 3: Enter the SIM card ICCID provided by the carrier;
Step 4: Enter the APN
of the SIM card inserted (provided by the carrier);
Step 5: Enter the username provided by the carrier for PAP/CHAP authentication;
Step 6: Enter the password provided by the carrier for PAP/CHAP authentication;
Step 7: Click
Save & Apply
.
Leave the field as is if not available.
PAP/CHAP username and password are to be specified only if your carrier has setup
APN with user name and password.
