Vantron
| Embedded in your success, Embedded in your better life
World-leading provider of embedded/IoT products and solutions
C335 Series Edge Computing Gateways | User Manual
54
WAN – Static Address
To activate static address protocol, select
Static address
in the drop-down list in the
General Setup
page as the protocol and click
Switch protocol
.
Upon click of
Switch protocol
, you’ll need to input the IPv4 address, subnet mask, IPv4
gateway, and the IPv4 broadcast. Custom DNS server could also be added.
Leave the field as is if not available.
When static address protocol is selected, DHCP server will be automatically disabled.
The advanced settings are basically same as those for DHCP protocol.
WAN – PPPoE
The general and advanced PPPoE settings for the WAN port are literally the same as those
above. Clicking on
Back or Refresh
will get you back to interface settings.
3.5.2
Wireless (WIFI)
You can switch between AP and client modes for wireless connection. Once again, this is
not applicable to C335
if 4G
/
LTE is chosen for wireless connection.