Vantron
| Embedded in your success, Embedded in your better life
World-leading provider of embedded/IoT products and solutions
C335 Series Edge Computing Gateways | User Manual
4
Precautions for Power Cables and Accessories
Use proper power source only. Make sure the supply voltage falls within the specified
range. Always check whether the Product is DC powered before applying power.
Place the cables properly at places without extrusion hazards.
Use only approved antenna(s). Non-approved antenna(s) may produce spurious or
excessive RF transmitting power which may violate FCC limits.
Cleaning instructions:
•
Power off the Product before cleaning
•
Do not use spray detergent
•
Clean with a damp cloth
•
Do not try to clean exposed electronic components unless with a dust collector
Power off and contact Vantron technical support engineer in case of the following faults:
•
The Product is damaged
•
The temperature is excessively high
•
Fault is still not solved after troubleshooting according to this manual
Do not use in combustible and explosive environment:
•
Keep away from combustible and explosive environment
•
Keep away from all energized circuits
•
Unauthorized removal of the enclosure from the Product is not allowed
•
Do not change components unless the power cable is unplugged
•
In some cases, the Product may still have residual voltage even if the power cable is
unplugged. Therefore, it is a must to remove and fully discharge the Product before
replacement of the components.
