Vantron
| Embedded in your success, Embedded in your better life
World-leading provider of embedded/IoT products and solutions
C335 Series Edge Computing Gateways | User Manual
39
3.3
Quick Start
3.3.1
Network Guide
This page provides a quick guide to such functions as rapid networking of the Gateway and
a display of the network port status and interface logic diagram. Refer to
for advanced settings.
Application of the network setup wizard will clear user-defined configuration
parameters.
Since C335L has only one Ethernet port that works in LAN area, WAN port settings are
not applicable to this model unless you configure it as a WAN port, in which case, WiFi
AP is bounded with the network bridge (br-lan) and ETH0 is to connect the higher-
level network for PPPOE/DHCP/Static mode settings.
For C335, Wi-Fi and 4G/LTE are designed to be alternative. Therefore, if you choose
4G/LTE for wireless connection, WiFi AP/client connections will not be applicable.
1.4/1.5/1.6 Definition of Interfaces
for the definition of the ports.
3.3.2
WAN setting – DHCP
DHCP
:
ETH0
and
WiFi (AP mode)
are bounded with the network bridge (br-lan).
ETH1
is
designed as the WAN port to connect the higher-level network. The cellular interface does
not work under this mode.
DHCP
setup procedures:
Step 1: Select
DHCP
for
WAN Protocol
;
Step 2: Click to switch the protocol to
DHCP
;
Step 3: Click
Save & Apply
.
Switch of WAN protocol will reset the network port topology and network parameters
to default values.
