Vantron
| Embedded in your success, Embedded in your better life
World-leading provider of embedded/IoT products and solutions
VT-SBC-3568 | User Manual 4
Precautions for Power Cables and Accessories
Use proper power source only. Make sure the supply voltage falls within the specified
range.
Place the cables properly at places without extrusion hazards.
There is a coin cell battery for powering the RTC. Therefore, please avoid short circuit of
the battery during transportation or operation at high temperatures.
Cleaning instructions:
-
Power off before cleaning the Product
-
Do not use spray detergent
-
Clean with a damp cloth
-
Do not try to clean exposed electronic components unless with a dust collector
Power off and contact Vantron technical support engineer in case of the following faults:
-
The Product is damaged
-
The temperature is excessively high
-
Fault is still not solved after troubleshooting according to this manual
Do not use in combustible and explosive environment:
-
Keep away from combustible and explosive environment
-
Keep away from all energized circuits
-
Unauthorized removal of the enclosure from the device is not allowed. Do not
change components unless the power cable is unplugged. In some cases, the device
may still have residual voltage even if the power cable is unplugged. Therefore, it is
a must to remove and fully discharge the device before replacement of the
components.
