Vantrue OnDash N3, User Manual

Setup

Resolution: 

By default, front camera is 1080P and rear cam is VGA. 1080P 

FHD, 720P, WVGA, VGA options are available for front camera.

Loop Recording: 

By default, this is set to 3 minutes per video clip. 3, 5, 10

minutes or OFF is available.

Night Mode *:

 Set to On by default. Can be turned OFF. 

GPS Setup: 

Set to Off by default,Can be turned on.

Motion Detection * *: 

Set to Off by default. Can be turned On.

Audio Record: 

Set to On by default. Can be turned Off.

Date Stamp: 

Set to Off by default. Can be turned On.

G-Sensor: 

Set to Medium by default. High, Medium, Low and Off options 

are available.

Touch to turn on/off 

voice recording.

Touch to snapshot.

Touch to go to the Setup menu. (if the camera is recording, 

press OK button or touch the “Stop Recording” to stop recording 

first, then go to the Setup mode.)

Record Setup

Date/Time: 

Touch ▲ or ▼ to set the current date and time. Touch Back 

to exit.

Parking Monitor *: 

Set to Off by default. Can be turned On.

Common Setup

* The night mode is triggered by LLL (low light level) night vision technology, 

which greatly enhances the camera’s vision in low light environment.

* * When the Motion Detection has been turned on, if no movement is 

detected in front of the camera after 10 seconds of recording, the camera 

will stop recording. Once it detects movement again, it will restart the 

recording.

Remark:

5