13
Gently insert the cartomizer into the vapor tank about ¾ of the way. Next, hold the cartomizer and tank at
a 45 degree angle and pour e-liquid down the outer edge of the tank until it’s about ¾ full. Then slide the
cartomizer the rest of the way into the vapor tank until the bottom flange slides home, and the carto is
sticking out the top of the vapor tank. Insert the tip into the cartomizer and give it a dry-hit (while not
pressing the activate button). Now you’re ready to go!
Periodically giving the device dry-hits pulls additional e-liquid into the cartomizer and will extend it’s life.
You’ll notice little air bubbles coming out of the carto holes. Give the device dry-hits until they no longer
appear.
Keep it wet!
The amount of visible vapor produced on exhale may vary depending on how you draw, condition of the
cartomizer, and the type of e-liquid used.
A cartomizer should last from about a week to three weeks depending on frequency of usage and care of
the cartomizer. Replace a cartomizer when airflow becomes obstructed, or there is any indication of a
burnt taste.
To replace a failing cartomizer: remove the vapor tank from the battery and remove the tip. If the vapor
tank still has remaining e-liquid inside, rinse it out with tap water. Then follow the pre-loading steps
previously with a new cartomizer.
Summary of Contents for Fogbank
Page 1: ...v1 3 ...