Vaporfi VAIO 75 TC, Manual

3

ATOMIZER PRIMING:

TANK FILLING:

Before using the VAIO 75w TC mod, there is a very cost saving measure that all users 
should take. That is priming the atomizer. Unscrew the top cap from the device, then 
proceed to unscrew the pre-installed 0.25ohm notch atomizer from that top cap. 
Once removed, take your e-liquid of choice and proceed to drip 1-3 drops of e-liquid 
into the atomizer head. Reattach atomizer to the top cap and proceed to fill your tank 
with your e-liquid.

After priming your atomizer and setting it aside, you are now ready to fill your tank. 
Take your e-liquid and proceed to fill the tank. Once you have filled the tank, screw 
the top cap back onto the device. Without pressing the power button, using short 
breaths, inhale from the drip tip up to five times and allow tank to sit for at least 10 
minutes to give the atomizer time to soak in your liquid. 

www.vaporfi.com

Note: 

To avoid flooding the atomizer, it is important to only fill half of the tank. 

Once the top cap with the attached atomizer is reattached to the device, the 
e-liquid with begin to rise. If there is too much liquid, there is a chance that the 
tank will flood, as well as the atomizer.