2. Safety Instructions
Please keep this User Guide for future use. If you sell the unit to someone else, be sure
that they also receive this User Guide.
•
ALWAYS make sure that you are connecting to the proper voltage, and that the line
voltage you are connecting to is not higher than that stated on the decal of the
engine.
•
NEVER use any liquid other than water and/or white vinegar in the unit. ONLY clean
potable water should be used. White vinegar should be added to prevent odors from
forming.
•
DO NOT allow water to flow into the air line. This will cause damage to the
VaporFlame units
•
DO NOT allow water to remain in the fixture when
not in use. This could cause an unpleasant odor or
bacterial growth in the water tubes.
•
In the event of an unpleasant odor the Engine and
Water Hoses must be cleaned immediately.
•
It is RECOMMENDED to add 2oz of white vinegar
to every tank of water to maintain clean internal
water hoses.
•
ALWAYS bleed remaining water and air from The
Engine before storing.
•
The Engine must be installed in a location with
adequate ventilation.
•
The Engine MUST be in a ‘lid up” orientation for
running.
•
Use The Engine for only one type of VaporFlame
fixture at a time. (Each fixture requires a di
ff
erent air
pressure and The Engine can only be set on a one
air pressure at a time.
•
The cable door must be open when the unit is
running. The cable door serves as the inlet for airflow. Closing or blocking the cable
door may cause The Engine to overheat.
•
ALWAYS drain the water tank prior to travel or storage.
•
DO NOT block fans on exterior of the case. Doing so may cause The Engine to
overheat.
•
Page of
4
11
Rev. 1.0 4/21
