Model No. VP-900
5
3. POWER SOURCE
1. The 3 station roof seamer motor requires a 20 amp
, 100-125 volt AC power
supply. Poor performance and motor damage can result from use of an
improper power supply.
Recommended extension cord size:
Distance (FT)
0-50
50-100
100-200
200+
Wire Gauge (AWG) 12
10
8
6
No other power tools should be run from seamer tool cord during seaming
operation.
2. Check Power Source, if seamer tool slows down or voltage
appears to drop.
A. There are three (3) possible reasons:
1. A lower rated cord than required is being used.
2. The power source is too far from seaming area.
3. Make sure no more than one (1) electrical power tool is
being operated off the single power source that is required for
the seamer tool.
3. Electrical requirements for 3/4 H.P.-10 Amp motor
A. 115 volt (minimum) - 60 cycle single phase
B. 20 Amp breaker minimum
Summary of Contents for SSR 900
Page 2: ......
Page 20: ...Model No VPHC 17 17 1 VP SSR HAND CRIMPING TOOL...