2920 Float & Tape Transmitter
9 L&J TankWay
114
Installation and Operations Manual
8. Press Minus or Plus to move to the appropriate number for this device.
Note
To backspace, press Minus to access the back arrow (
). Press Enter to backspace.
9. If the 2920 Unit Address requires a two-digit number, press Enter to move to the next digit.
10. Select the second digit using Minus or Plus.
11. Press Enter to select the Return arrow (
) and save the 2920 Unit Address.
12. Press Cancel to exit each menu and return to the Home display.
To Set the 2920 FTT Gauge Type
1. Follow steps 1 through 5 in the 2920 FTT unit address procedure (above).
2. In the Config Params menu, select Gauge Type.
3. Press Enter to modify the Gauge Type parameter.
4. Press Minus or Plus to select the appropriate Gauge Type setting for this device.
5. Continue following steps 9 through 12 above to complete the Gauge Type setup.
To Set the 2920 FTT Encoder Type
1. Follow steps 1 through 5 in the 2920 FTT unit address procedure (above).
2. In the Config Params menu, select Encoder Type setting.
3. Press Enter to modify the Encoder Type parameter.
4. Press Minus or Plus to move to the appropriate Encoder Type setting for this device.
5. Continue following steps 9 through 12 above to complete the Encoder Type setup.
To Set the 2920 FTT Level Display Units
1. Follow steps 1 through 5 in the 2920 FTT unit address procedure (above).
2. In the Config Params menu, select Level Display Units setting.
3. Press Enter to modify the Level Display Units parameter.
4. Press Minus or Plus to move to the appropriate Level Display Units for this device.
5. Continue following steps 9 through 12 above to complete the Level Display Units setup.
To Set the 2920 FTT RTD Type
1. Follow steps 1 through 5 in the 2920 FTT unit address procedure (above).
2. In the Config Params menu, select RTD Type.
3. Press Enter to modify the RTD Type parameter.
4. Press Minus or Plus to move to the appropriate RTD Type for this device.
5. Continue following steps 9 through 12 above to complete the RTD Type setup.
To Set the 2920 FTT Temp Display Units
1. Follow steps 1 through 5 in the 2920 FTT unit address procedure (above).
2. In the Config Params menu, select Temp Display Units.
Summary of Contents for 2920
