User Manual: UM50566-EN
Optica 30/40/50 series
Revision: 3.0
Date of release: 2019-01-09
28/36
www.vareximaging.com
4.
Troubleshooting, maintenance and service
This chapter describes troubleshooting, cleaning, maintenance and service.
4.1.
Troubleshooting
Information about troubleshooting can be found in the Technical Manual.
4.2.
Cleaning
Cleaning procedures and agents
Follow local, national and organizational procedures regarding cleaning. The following agents are safe
to use:
Agents
Isopropanol
Ethyl alcohol
The cleaning agents above may be diluted with water for cleaning purposes.
WARNING:
Use of cleaning agents other than described to be save may result in damaging the
collimator or possible injury to the user.
Cleaning recommendations
-
Make sure the collimator is switched OFF (see §3.1 for instructions)
WARNING:
Use of abrasive cleaning could result in deterioration of the collimator. E.g. the crosshair
window can be damaged which will result in reduction of light field illumination.
-
Do not use abrasive cleaning products.
WARNING:
Do not spray, pour or soak the collimator with liquids.
-
Use a damp soft cloth to clean the collimator, this will reduce the possibility for liquids
to enter the collimator. Use a dry soft cloth to remove any residuals from the collimator.
4.3.
Maintenance and service
Information about maintenance and service of the device can be found in the Technical Manual.
4.4.
Safety precautions
When there is structural damage to the housing of the Collimator, label the Collimator as “out of order”
and have the Collimator repaired prior to further use.
