KC-435
21
1.6.4
Putting the machine into operation after longer storing
Dismount the spark plug and check its condition. If necessary, adjust the required electrode gap and clean
it. Pull the starter handle several times and crank the engine.
Install the spark plug back and fix it properly. As soon as the spark plug fits on the seat, tighten it for 1/8-
1/4 revolution only.
Check the quantity and condition of the engine oil.
Add the prescribed type of fuel into the fuel tank and start the engine.
The spark plug must be properly tightened. If it is not tightened sufficiently, there’s a risk of
spontaneous unscrewing of the spark plug and damage to the engine or injury to the operator. Use only
spark plugs with corresponding temperature characteristics. Using spark plugs with other characteristics
can result in serious damage to the engine which is not covered by the warranty.
Note:
If the engine was treated with a preservative oil coating before storing, it will smoke at the beginning.
1.6.5
Disposal of the wrapping and the machine after the end of its life time
After unwrapping the machine the user is obliged to dispose of the wrapping according to the national laws and
regulations concerning waste treatment.
Following steps are recommended for the disposal of the machine after the end of its life time:
Dismount all parts which can still be used.
Drain the oil from the gearbox into a suitable closable container and take the oil to a waste collection
point
17
.
Dismount parts from plastics and non-ferrous metals.
Dispose of the undressed machine rest and dismounted parts according to the national lawn and
regulations concerning waste treatment.
1.6.6
Instructions for ordering spare parts
The spare part list is not included in this manual. The latest version of the catalogue can be downloaded from our
web site. If you have no access to the internet, you can ask your dealer for a printed version. Following data are necessary
for correct identification of your machine:
Type name (Type)
,
Part number (CN°)
and production
Identification number
(N°)
. Only with these data is it possible to find the exact designation of the corresponding spare part.
Field
Description
Type
Type name of the machine. (
KC-435
)
N
o
Unique production identification number.
1005200006.0111.00001
(product.period.quantity)
CN
o
Part (trade) number. (
4339
)
Table 7: Name plate – example
1.7
Address of the manufacturer
VARI, a.s.
Phone: (+420) 325 607 111
Opolanská 350
Fax:
(+420) 325 607 264
Libice nad Cidlinou
289 07 Czech Republic
E-Mail:
vari@vari.cz
Web:
http://www.vari.cz
17
The place for handing it in will be advised by a local authority.
