DS-520 Líza
DS-520H Líza
11
5.3 Starting the mowing disk.
,
When starting the engine, the control bar of the mowing disk drive clutch on the
handlebars must be in the off position.
1. Start the engine. When doing this, follow the instructions presented in the operating
manual for engine use.
2. Set-up maximum engine rotations by accelerator lever on the right handle. (Should the
engine be cold, let it warm up at a maximum speed for about 30 seconds.)
3. Grasp the handlebar grip with both hands. Then pull the control bar of the mowing disk
drive gear to yourself.
,
Press the bar slowly up to two thirds of the stroke so that the mowing disk can start
rotating and the engine does not stall.
The start of the mowing disk is accompanied with a partial V-belt slippage and with the
related phenomena such as whistling, rattling, etc. that usually disappear after the belt has
run in.
4. After the mowing disk has started turning, press the bar completely to the handle and
hold it firm.
Note: In a new or cold engine, engine stalling may occur at several first mowing disk
drive starts. The phenomenon will disappear after the engine gets warmer.
5.4 Driving the mower.
In order to initiate its moving forward, you have to push the mower. Instructions for
machine travel see Chapter 5.6.2.
Control
bar
Accelerator lever
(engine speed
adjustment)
Figure 3: Handlebars with steering elements
CHOKE
(engine GCV
135 only)
MAX
MIN
STOP
Summary of Contents for Liza DS-520
