TRIMMER-50
TRIMMER-60
12
5.2
Putting into operation
Read the instruction for engine use thoroughly! You can prevent a possible
damage to the engine.
1.
Fill the engine with the prescribed types and volumes of oil and petrol.
2.
Instructions for making the motor ready for starting and instructions for proper
engine start see the operating manual for engine use.
3.
Let the new or cold engine running for about 1 min with the accelerator lever in the
MAX
position.
Figure 2
5.3
Starting the mowing tool
1.
Start the engine (if it is cold, let it running for about 1 min to warm up). At doing
this, follow the instructions presented in the operating manual for engine use.
2.
Set-up maximum engine rotations by means of accelerator lever.
3.
Grasp the handlebars with your left hand and pull the control horizontal bar to the
handlebars with your right hand until the string head starts turning. Hold the
horizontal bar near the grip at working.
The start of the string head can be accompanied with rattle or whistle due to a partial
slippage of the V-belt during the switching. The phenomenon usually disappears after
the belt has run in.
! The aerodynamic noise (whizz) resulting from a high circumferential speed of
the string is characteristic of the string mowers. The phenomenon cannot be
rectified and does not signal any defect or failure!
CHOKE only
in
TRIMMER-60
MAX
MIN
STOP
Axle arrestment lever
Accelerator lever
Control horizontal
bar
