TRIMMER-50
TRIMMER-60
15
! Always replace both the strings. Poor balance of the string head may result in a
machine damage.
Caution!
When mowing in the stand with a lot of solid objects, near walls, fences or
curb stones, a string breakage occurs more frequently, resulting in the reduction of
machine engagement width or in the complete string loss. It is advised that the operator
has a sufficient amount of spare strings on him.
! When working with the TRIMMER-50 machine, don’t increase the machine
engagement width above 50 cm. The engine may be damaged due to overloading.
! When working with the TRIMMER-60 machine, don’t increase the machine
engagement width above 58 cm. Danger of damage to the string head protective
casing.
5.6.3
Adjusting the mowing height
! The adjustment is to be made with the engine switched off and the spark plug
cable disconnected.
The machine is equipped with a string head which enables adjustment of 3 mowing
heights. The mowing height adjusted by the manufacturer is the lowest one.
Mowing height adjustment procedure:
1.
Put the machine onto a firm base so that you have a good access to it. Secure the
machine against spontaneous movement.
2.
Loosen and unscrew the bolt with fillers (barrel spanner No. 16 supplied with the
machine) fastening the string head assembly to the shaft.
3.
Dismount the lower support disk, disk with strings and distance rings.
4.
Reassemble the string head to the required mowing height according to figures 7, 8
and 9.
5.
Screw the bolt back and tighten it properly (tightening moment is 15 N.m)
Minimum
Medium
Maximum
Figure 7
Figure 8
Figure 9
