TRIMMER-50
TRIMMER-60
16
5.6.4
Tilting of the machine
Machine tilting to sides (out of machine axis) is used for final trimming near curb
stones, fences or walls (edges in general), i.e. at places impossible to reach with a
common grass mower.
Tilting is to be made as follows:
1.
Press the axle arrestment lever (see Fig. 1) down with the thumb of your right hand
until the arrestment pin is released.
2.
Tilt the machine mildly backwards and turn it by means of handlebars to the desired
side (left or right). The machine axis is a turning point at this moment.
3.
Release the axle arrestment lever and in the case that the arrestment pin does not fall
in, swing the machine slightly until the pin falls in. Return the machine into its
working position.
Tilting to the left Tilting to the right
Figure 10 Figure 11
5.6.5 Problems at cutting
•
If the engine is markedly loosing speed (engine is choking), the engagement width
and the travel speed should be accommodated to the density and height of the grass
stand.
•
If the mown stand width does not correspond to the nominal engagement, check the
strings for intactness or replace them with new ones.
•
If the string head rotations do not reach nominal values without load (engine is
choking), remove the grass wound up onto the string head hub. If the engine is still
choking, check its condition and make sure that the string head can freely turn.
