4. Loosen both multiplier retainer screws one turn.
5. The retainer bracket will swing down and out of the way, in the direction of
the arrow, allowing the multiplier to be lifted out.
6. Lift out the multiplier
Installing the New Multiplier
1. Place the multiplier into the holder as shown. The multiplier must be fully
engaged by the clip at the bottom of the holder by pressing down and to the
left as shown. Failure to properly engage the clip adversely affect
performance. The horn should be near the centerline of the plastic holder.
2. Swing the holding bracket back into position and tighten the bottom screw.
3. Tighten the top screw.
80 of 127
Summary of Contents for 4000 GC
