CP-3800 GC Operator’s Manual
109
The following page is accessed by pressing the Adjustments softkey.
ACTIVE
METHOD
EDIT
METHOD
CTRL
RUN
TIME
END
TIME
Method 1
Method 1
0.00
20.00
Set (°C): 300 Actual (°C): 300 Signal (mV): 5.15
FRONT FID ADJUSTMENTS, Page 1 of 2
Time Constant:
Fast
Clear AUTOZERO
The second adjustments page is only accessible if detector EFC is installed.
ACTIVE
METHOD
EDIT
METHOD
CTRL
RUN
TIME
END
TIME
Method 1
Method 1
0.00
20.00
Make-up Flow (ml/min): 25 H
2
Flow (ml/min): 30
Air Flow (ml/min): 300
FRONT FID ADJUSTMENTS, Page 2 of 2
Make-up Flow (ml/min)
25
H
2
Flow (ml/min)
30
Air Flow (ml/min)
300
Installation/Disassembly
At times, it is necessary to remove the detector components to inspect, to
clean, to replace parts, or to install another detector. Follow the
disassemble/reassemble instructions below for both the FID and the detector
oven.
Figure 13 is an exploded view of the FID. Refer to these figures as you
disassemble the detector.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
